Mine and steves project.

Picked it up off Ben last week like this.


Got 12 months MOT on it now just needs 2 rear brake flex's which i already have and a pair of front CV boots but got a spare set of shafts.

Got a spare pair of 16v rear lights put on today along with the RA's off the white 16v then gave it a good clean and polish. Rivets on most of the arch's were rusted and not holding the arch trims on. Rivets replaced and all arch's ok.






Front wing needs to be sorted as down to primer in a couple of places.


Drives mint just clutch bite is a little high.

Looks well.
The RA's suit it much better than the 5 spokes...

you like to keep yourself busy don't ya!
Looks like a good base for a project

very good base paul what are the plans then ?? them 5 spokes look very 90's lol ra'slook mucho better is it 8 or 16v ??

Just an 8v for knocking about in and transporting bits to fit on the 16v.

Kev at ice beat has it now getting a cat 2 fitted. Should get it back on saturday.

Sold the 5 spokes for £180 to a lad on ed38 lol.

No stopping the Worthington brothers. Nice more door mate.

Those 5 spokes were nice! Looked like Azev C's?

Lookin tidy mate

G60 PB wrote:

Those 5 spokes were nice! Looked like Azev C's?

Tyres were to wide and got a bit of catching on the back. Lot easyer to put on the RA's than buying a new set of tyres.

haha ed38 nevers fails to amaze me you could sell anything on there and make a profit i sold my g60 steels for 200 i only paid 120 for the lot lol

Looking good steve, RA's look much better. Did you manage to sell the passat in the end or go for the twingo.

ben

Steve went for the twingo in the end. Passat goes end of march time.

Fitted new leather gear gaitor.
New front mount.
Replaced rusty sunroof deflector arm so the sunroof closes with no helping hand required.
Adjusted throttle cable.

Got a set of smoked front and side repeater to go on.
Found a set of front speaker grilles in the parts bin so ordered a set of speakers to go in.

you got any major plans then paul or u just keepin it simple?

No plans mate just using all the spare parts in the garage from the 16v.

haha sounds the best plan keep it simple and tidy

Spent a bit getting all the salt off it today after running around everywhere.

Got my spare 16v drive shafts and gave them a clean and paint.


Smoked front indicators as body of the drivers one was all rusty inside.


Fitted a spare pair of speaker grille's with sony speakers in.

and so it begins lol

Sold :P